TP-LINK N600 Instalační příručka

Installation GuideWireless N Access PointEAP110/EAP120/EAP220

073. Use a drill with the appropriate size drill bit to drill three 4mm holes for the pan-head screws, and drill a 10mm hole for the Ethernet cable t

085. Attach the EAP to the mounting bracket by aligning ARROW 1 with ARROW 2, as shown below. RESETETHERNETARROW 2ARROW 16. Turn the EAP clockwise u

097. Feed the Ethernet cable through the hole and set the ceiling tile back into place.8. Connect the Ethernet cable to the ETHERNET port. Wall Mou

104. Attach the EAP to the mounting bracket by aligning ARROW 1 with ARROW 2.RESETETHERNETARROW 2ARROW 15. Turn the EAP clockwise until it locks int

114. Power Supply EAP110The EAP110 can be powered with the provided PoE adapter. 1 2SwitchEAP110PoE Adapter3POE LANPOE LAN(Up to 100m)1. Connect th

12 EAP120/EAP220EAP120/EAP220 can be powered via a PSE device (such as a PoE switch) or a power adapter.Via PoE SwitchEAP120/EAP220PoE Switch121. Co

13Software ConfigurationThe following content will guide you to quickly set up a wireless network connection with mass EAPs, and log in to the EAP Con

14Q&AQ1.What is the maximum cable length between the EAP110 and the provided PoE adapter?100 meters. The quality of the Ethernet cable may influe

15SpecificationsHARDWARE FEATURESModel EAP110 EAP120 EAP220Interface Kensington lock slotRESET buttonETHERNET:10/100MbpsEthernet port (RJ-45)ETHERNET:

COPYRIGHT & TRADEMARKSSpecifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other bra

CONTENTSAbout This Installation GuideThis guide is designed to familiarize you with the general layout of the EAP110, EAP120 and EAP220, describe how

01Network TopologyA typical network topology for the EAP is shown below.Controller HostEAPControllerRouterSwitchInternetEAPClientsTo deploy an EAP in

02Hardware Overview1. LEDEAP110, EAP120 and EAP220 have the same LED status and corresponding indications. System LEDLED Status IndicationSolid green

032. Interface Panel EAP110ARROW 1RESET ETHERNET EAP120/EAP220 ARROW 1RESETCONSOLE ETHERNETON/OFFPOWERPlease note that EAP110 does not have the CONS

04ON/OFFPress this button to turn on/off the EAP120/EAP220.POWERThe power port is used to connect the EAP120/EAP220 to an electrical wall outlet via p

05Hardware InstallationThe EAP can be wall-mounted or ceiling-mounted. Please suitably arrange your wire layout before mounting the EAP. We take EAP11

063. Installation Ceiling MountingNote: Make sure the thickness of the ceiling is less than 18mm and the ceiling can bear at least five kilograms.